RAM 4000 Manuel d'instructions télécharger pdf (Page 7)

(3) THE FIXATION OF THE BOTTOM

Make sure the reliability of the floor surface (The minimum area

is 43.5×41.3in.). While positioning, the detailed procedures and the

dimensions are as shown in the following pictures:

A) Place the bolts into the holes, which depth is 1.97in. Cover the

bolts with nuts when adjusting.

B) Remove the nuts and put the vending machine at a level

position.

C) As shown in Picture IV, position the bottom board to the foot

and the bolts, cover the mats and screw down the nuts with a wrench.

(4)ELECTRICAL POWER NEEDED

Refer to the nameplate of machine to determine the proper

voltage and frequency the machine requires(115VAC,60Hz,6.9Amp

circuit).DO NOT USE AN EXTENSION CORD.

Mult i-Level Surface

Picture I

Horizontal and Hard Surface

Sla nted Surface

Swampy Surface

1 2 3 4 5 6 7 8 9 10 11 12 ... 49 50

Pas de commentaire

RAM 4000 Manuel d'instructions Page 7