RAM 6000 Informations techniques télécharger pdf (Page 63)

Software Manual 63

Network Tab

Warning: When enabling switch mode, current ethernet settings (eth0) will apply only to the single WAN port. On the front of

the unit, this may be shown as <Port 5> under the power connector. The remaining four ports will be configured as a

LAN (eth1).

Please check your Ethernet connections to make sure that the new settings will not conflict with previous network config-

urations. You may need to revisit your Untrusted/Trusted interface lists in the Firewall -> General Settings, as these will

revert to new defaults (eth0 will be firewalled as Untrusted!). After Apply is clicked and you check firewall/ethernet config-

urations, a reboot is required to complete this process.

• Click on the “Save” button for changes to be saved without activating the interface, the “Apply” button will save

your settings and apply them immediately. To revert to the previous defaults, click on the “Revert” button.

3.4.2.6 PPP Dial Backup

The PPP Dial Backup menu item is used to configure the capability of an alternate connection by dialing into an ISDN

should the primary router get interrupted.

• Click on the PPP Dial Backup menu item and the following dialog window will appear:

Enable PPP Dial Backup: Select YES to turn on the PPP Dial Backup and NO to turn off PPP Dial Backup.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 210 211

Pas de commentaire

RAM 6000 Informations techniques Page 63